SikaLatex®

Styrene butadiene emulsion

12 months shelf life from date of production if stored properly in undamaged, unopened, original sealed packaging.

Storage at temperatures between 5 °C and 30 °C. Protect from direct sunlight, frost and contamination.

~1.0 kg/l

~8.0

Min. 5°C – Max. 35°C 

Min. 5°C – Max. 35°C 

Bonding Bridge:

Mix SikaLatex® with water to produce a gauging solution in the correct ratio. Add gauging solution to cement-aggregate mix until desired consistency is achieved. The prepared substrate should be thoroughly soaked with clean water until uniformly saturated leaving no standing water. Work mix vigorously with a stiff brush onto pre-dampened substrate. Always apply screeds / render / mortars “wet on wet” onto bonding bridge.

Cement : Sand : Liquid (1 part SikaLatex® + part water) = 1 : 1 : 1 (by volume) or

Cement : Sand : Liquid (1 part SikaLatex® + part water) = 1.5 : 2 : 1 (by weight)

Apply the slurry onto the pre-wetted substrate in 1- 2mm thickness and apply the subsequent mortar renders immediately (wet onto wet application).

Mortar Admixture:

Up to 25 kg of Sikadur Aggregates should be added where the thickness per layer exceeds 12mm

Mix SikaLatex® with the correct amount of water to produce a gauging solution.

Pour part of the gauging solution into a suitable mixing container. While stirring slowly, add the cement-sand mix to the gauging solution and mix thoroughly until a smooth, uniform and lump-free mix is achieved. Within the mixing time add additional gauging solution to adjust to the desired consistency.