SikaCeram®-80 TZ
SikaCeram®-80 TZ is an adhesive mortar, easy to use with addition of water, cement-based, special fillers and additives for laying tiles internally (horizontal).
- Very good adhesion
- Easy to use with excellent workability and thixotropic consistency
- Non Toxic
Usage
SikaCeram®-80 TZ is suitable for bonding:- Ceramic tiles.
- All types of very high absorption tiles.
- Concrete
- Cement mortars
- Bricks
Advantages
- Very good adhesion
- Easy to use with excellent workability and thixotropic consistency
- Non Toxic
Packaging
25 kg
Colour
Grey Powder
Product Details
Shelf life
12 months in its original, undamaged packaging
Storage conditions
Undamaged original sealed packaging, protect from humidity and excessive heat.
Maximum grain size
0.5 mm
Application
Mixing ratio
Add about 6 -7 liters clean potable water to a 25 kg bag. Mix mechanically using a forced action mixer or slow speed drill (< 500 rpm) and mixing paddle for at least 3 minutes until a homogeneous mix, free of lumps is achieved. Do NOT use a normal free fall concrete mixer. Do not mix more material than can be used within the open time. Leave material to stand in mixing container until the majority of bubbles have dispersed (minimum 10 minutes). Then remix the material for 15 seconds – the product is now ready for use. If open time is exceeded or the adhesive dries prematurely, remove tiles and re-apply using fresh material
Fresh mortar density
1.71 kg/litre when wet mix at 25°C
Layer thickness
Minimum 2mm
Maximum 5mm
Ambient air temperature
Minimum: +8°C
Maximum: +40°C
Substrate temperature
Minimum: +8°C
Maximum: +35°C
Open Time
20 minutes (25 °C) (EN 1346)
Curing time
Before jointing / grouting works - Min 24 hours
Before opening to light foot traffic - Min 24 hours
Before opening to full traffic - Min 14 days
Adjustability time
Once the tiles are set into the mortar, they can be adjusted for up to approximately 30 minutes (at +25°C)
Consumption
The consumption depends on the surface profile and roughness of the substrate and the placing technique (simple placing or back-back-“buttering”). One 25 kg bag will cover approximately 5 – 7 m2
APPLICATION
Apply SikaCeram®-80 TZ at 2 - 5 mm thickness directly to the concrete substrate, using a notched trowel and spread the mortar evenly over the area to be tiled. Cover only an area that can be tiled within 15 - 30 minutes. Apply with “V”-notched trowels for small tiles. Apply with square notched trowel for bigger tiles. Press tiles firmly into the mortar with a twisting action to ensure optimum adhesion.
CLEANING OF EQUIPMENT
Clean all equipment and tools with water immediately after use. Dry hardened material can be removed mechanically